This installation of the sewer is a bounce water with overflow holes. The installation steps of the other sewer are similar to this one.
First, take out the sewer.
Remove the fixed parts from the bottom of the sewer and the flange.
Second, remove the fixed parts of the bottom of the sewer and the flange.
Pick up the sink. Get the flange out
Three, pick up the basin. Take the flange out of the sewer.
IV. Fasten the flange of the sewer to the basin.
V. After the flange is tightened, put the basin flat on the table and the mouth of the water inlet to the good table.
Wound the raw material belt in proper position to prevent water seepage
Six, in the appropriate position of the sewer winding on the raw material belt, to prevent water seepage.
Seven, put the sewer on the water inlet of the basin.
Eight, put the water into the water inlet of the basin.
Nine, put the water into the basin of the mouth, put flat.
Take out the retainer of the sewer and twist it on the sewer.
Use a spanner to fasten the sewer.
12, the water in the basin to test.